INSTALLATION:

Adhesive Vinyl (wet mount)

You Will Need:
   - paper towels (to dry surface)
   - squirt bottle (filled w/ 80% water and 20% dish soap)
   - squeegee/credit card (to remove air bubbles)
   - a scraper (to remove dirt/dust from surface)

Online Sign Shop - Outdoor, Photographic, Vinyl Signage

  1. Wash area where you are going to stick the sign
  2. Peel off the backing of the sign
  3. Wet sticky side of sign (this prevents sign from sticking until step 6)
  4. Hang sign in desired location (you will be able to move it around)
  5. Smooth sign (check everything is level and straight)
  6. Squeegee sign from center outwards (removes excess water & makes sign stick)
  7. Set the sign for about 24 - 48 hours as adhesive cures.

Adhesive Vinyl (dry mount)

You Will Need:
   - Two people
   - Squeegee/credit card
   - Pin (needed to poke holes in air pockets)

  1. Wash vehicle surface thoroughly
  2. First person holds sign and second person peels off a small portion of the backing (leaving only a small part of the adhesive exposed)
  3. Second person sticks a small piece of the sign to the vehicle surface surface while the first person pulls at the vinyl creating tension.
  4. Second person squeegees vinyl as each portion is stuck to the surface.
  5. Do not leave any pockets of air in contours of vehicle.  If you have to poke holes in the air pockets and smooth vinyl on surface.

IMPORTANT: The sign will stick extremely fast to the first smooth surface it touches.  Beginners should use wet mount.